HOW TO SHOOT CRACK RESIN HIT HOW TO

So what I'm gonna do is I'm gonna let this sit for 15 minutes, try to let those bubbles rise and pop on their own and then if they don't I'm going to quickly shoot it with the micro torch just to get rid of some of the bubbles so that when we do another layer of resin on top of this and embed an object in there, it's gonna look like one nice solid even layer it's been about 15 minutes. Make sure it goes all the way up to the edges try not to touch that tape layer I'm happy with that. Just make sure that you go all the way to the edges so you have a nice solid even layer I would recommend making at least an 1/8 of an inch thick just for stability I'm carefully dripping my resin into the center it's dispersing on it's own push it around. You can make this layer layer or as thin as you like. I like to pour actually using the stir stick which is just a popsicle stick as my applicator and I'm going to pour right onto the tape. Make sure you don't poke into the tape trim that a little bit more just work your way all the way around when that's done flip it over and I'm going to pour some resin into the inside of the bezel. I'm just really making sure that I have a good solid seal around the entire edge do that just by rubbing it with the burnishing tool. So now I'm going to flip it over and use my burnishing tool to burnish the edge. We also want to make sure that we don't our fingerprints all over the backside I'm going to take a nice clean length, cut it without touching the area where I'm gonna put my bezel I'm just gonna go ahead and lay it on top of the sticky side of the packaging tape I'm going to trim this a little bit just for my own convenience and I can touch all around here I just can't touch that center. I'm actually just going to cut this time. I want to show you, see these lines on here you wanna try to use a clean piece of tape We want try to make it so that we don't have any of those little lines.

HOW TO SHOOT CRACK RESIN HIT HOW TO

There's a bunch of them on the market you can pick them up in any type of office supply store usually at got a torch to remove my bubbles and then I've already gone ahead and I've mixed up some resin and if you're not familiar with how to mix resin and we do have other tutorials showing you how to do it but this is ready to go and I'm going to show you right now how to do this so what we're going to take a length of packaging tape now make sure your packaging tape as wide enough for your bezel. This came out of my clay kit but you can actually even use perhaps the backside have a kitchen knife, something like that and you'll see what I'm going to do with that in a moment You'll need some adhesive remover This is just one brand. You're going to need some packaging tape, scissors to cut that tape a burnishing tool of some sort. This one is Nunn Design I has a really pretty edge to it. Hi, this is Julie with and I'm going to show you how to fill a open back bezel you can see that there's no back in here, with resin so that we can make a pendant You'll need an open back bezel. Note: This audio transcript is auto-generated and may not be completely accurate.

How to shoot crack resin hit